Run one script on several mobiles

This procedure is used to run a single End User Experience script simultaneously on several mobiles. Each virtual user instance represents the execution of the script on one mobile, with re-execution of the script at each new iteration of the Actions container. The load corresponds to the number of mobiles to be tested.

In this example, we will assume that we must test 3 mobiles ("Device Under Test" or "DUT"), which are identified with the following IDs: "034F1E2", "5A18F34", "3BAA91B".

  1. Create a new NeoLoad List Variable type named "DUT". Enter the DUT values and In the Value change policy section, select For each Virtual User.

  2. In a Virtual User, add an Advanced action and configure the parameters.
    For more information on the configuration of Advanced actions, please refer to the Advanced actions page.
  3. Enter the name of the script to be run.
  4. Enter the name of the mobile to be tested, using the previously created variable ${DUT.col_0}.

  5. Create a population and add the previously created virtual user.
  6. In the scenario, add the previously created population with a load of 3 Virtual Users, because there are 3 mobiles to be used.

The scenario must be updated every time a mobile is added or removed: