Previous Topic

Next Topic

Book Contents

Book Index

Execute NeoLoad on the command line

Tip: Before executing NeoLoad Controller, you can configure its properties via the environment. The Controller properties can be edited by setting the corresponding environment variable. However, modifying the environment variable overrides the properties set in the controller_user.properties file and in the controller.properties file. Below is an example of how to add an environment variable corresponding to a given Controller property key:

Controller property key

Environment variable

[Recorder]

controller.recorder.pause=1000

NL_PROPERTY_RECORDER_CONTROLLER_RECORDER_PAUSE=1000

The standard format is: "NL_PROPERTY_CATEGORY_MY_PROPERTY=value"

  1. Execute <install-dir>\bin\NeoLoadCmd.exe
  2. Type the commands to execute the NeoLoad options you want.
  1. Execute <install-dir>/bin/NeoLoadCmd
  2. Type the commands to execute the NeoLoad options you want.

In This Section

List of arguments

Exit codes

See Also

Start the Controller

Open the Graphical User Interface

Use NeoLoad with ANT

Start NeoLoad in non-privileged mode