When the project relies on Cloud resources to execute, the Execution Sanity Check wizard may display the following issues.
.
Message |
|
Description |
The test cannot start because it is configured to use the "localhost" Load Generator on the Cloud Controller machine. This Load Generator can be used to check the Virtual User only. For performance reasons, it cannot be used to generate Virtual Users load. |
Resolution |
In the Cloud Controller, the "localhost" Load Generator must be unselected in the Load Generators group box of the Scenarios tab in the Runtime section. For more information, see Test settings. |
.
Message |
|
Description |
The test cannot start because it is using a Cloud Load Generator which is active but not running. Its Y status may be "rebooting". |
Resolution |
For a "rebooting" Cloud Load Generator, it is necessary to wait for it to be running. For more information, see Cloud Load Generators. |
.
Message |
|
Description |
The predefined duration of the test to start is longer than the duration of the session. |
Resolution |
The duration of the test must be shortened, as described in Duration policy, or the duration of the Cloud session must be extended, as described in Modify a reserved Cloud session. |
.
Message |
|
Description |
The duration of the test to start is undefined while the session will stop in less than 30 minutes. |
Resolution |
The duration of the Cloud session must be extended, as described in Modify a reserved Cloud session. |