On Windows

Installing the Controller requires the administration rights.

• To install the Controller with the GUI installer

• Run neoload_7_4_0_windows_<bitness>.exe, and select the Controller installation option.

• To install the Controller in console mode

• Run the command line start /wait neoload_7_4_0_windows_<bitness>.exe -c

• To install the Controller in silent mode

• Create a "response.varfile" file including the following content:

  # install4j response file for NeoLoad Controller

  executeLauncherAction$Boolean=false

  installService$Boolean=false

  startOnBootUp$Boolean=false

  sys.adminRights$Boolean=false

  sys.component.Common$Boolean=true

  sys.component.Controller$Boolean=true

  sys.component.Controller\ Agent$Boolean=false

  sys.component.Load\ Generator$Boolean=false

  sys.component.Monitor\ Agent$Boolean=false

  sys.installationTypeId=Controller

  sys.languageId=en

  sys.programGroupDisabled$Boolean=true

• Run the command line neoload_7_4_0_windows_<bitness>.exe -q -c -dir <installdir> -varfile response.varfile

Information: When installing a Controller on Windows, the WAN Emulation driver is automatically installed too, as documented in Install the WAN emulation.

• Warning: The "windivert32.sys (or 64) WAN emulation driver can be detected as a malware on windows depending on the antivirus configuration. It is not mandatory if you don't want to use the WAN emulation. If you want to use WAN emulation please whitelist "windivert64.sys" or "windivert32.sys" depending on your system (32 or 64 bits).